VIORE LC40VF60CN - Manual (Page 7)

5
Introduction
Introduction
1. Front View
1). (IR) Infrared Receiver: Receives IR signals from the remote control.
(Power on/Standby)LED Indicator: Press POWER to turn on and off.
Indicator on(Red) Standby mode
Indicator on(Green) Power on mode
2). The functions of the buttons:
INPUT: Press to display the input source menu.
MENU: Press to display the OSD menu,
press again to exit the menu.
CH+/-: Press to scan through channels.
VOL+/-: Press to adjust the volume.
POWER: Turn on/standby the TV set.
The effective receiving range for the signal is 5-8 metres from the front of the remote
control window, and 30
0
to the left or right side and 20
0
above or below the remote control
window.
Press INPUT button on the TV set or the SOURCE button
display the input source menu,
the TV set or / button on
input source, press OK button
enter.
Note: Before you select the input source, make sure the
connections are prepared.
Led Indicator Remote Control window
(Keep clear)
on the remote control to
CH+/- button on and use
remote control to select the
on the remote control to
INPUT
MENU
CH+
CH-
VOL+
VOL-
POWER