VACUUBRAND BVC 21 NT VARIO - Manual (Page 26)

Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999157 / 10/12/2009
page 26 of 31
Assembling of components
Remove screw cap from bottle. Remove the blind cap (loosen
locknut inside the screw cap).
Insert lead-through (2) with coupling (1) (Attention: Parts are
sealed with adhesive for leak tightness) and with seal ring (3)
through the screw cap. Push hose (5) onto lead-through and
fasten hose (5) under the screw cap with locknut (4). Adjust
hose towards flask wall. Assemble screw cap.
Ensure that there is no liquid in the tube, risk of contamina-
tion!
Remove connecting tube from the filter. Remove the filter
from the piece of tube at the hose nozzle. Assemble new filter
(position with the printed side towards the bottle) and assem-
ble connecting tube.
Ensure that there is no liquid in the tube, risk of contamina-
tion!
Remove adapter from the fixing clip. While pressing the con-
trol button, pull out the aspiration tube.
Assembling new aspiration tube:
While pressing the control button, insert the new aspiration
tube between thumb wheel and roller. Insert adapter into the
aspiration tube. Support the fixing clip suitably and assemble
the adapter to the fixing clip.
Replacing the aspiration tube at the VHC
Replacing the filter
Assembling a second connection set VHC
filter
blind plug
1
2
3
4
5