TYREDOG TD-1300A-X5 Owners Manual User Manual
Page 14
13
Installation
The LCD monitor can be powered by 2x AAA batteries, or your car’s power by
using the supplied cigarette lighter adapter. Please follow the steps below
outlining how to install batteries into the monitor and sensors and powering
up the system for the first time.
Using your thumb, slide the battery cover toward the top of the monitor.
Insert the negative end of the battery onto to the spring side of the battery
holder and push the other end in until it locks in place. Be sure the battery
polarity is correct and replace the cover. The polarity is also marked inside
the battery area. When the batteries are inserted correctly, the monitor will
power up, and the home screen will be displayed within a few seconds.
The home screen will be shown like this for the first time until sensors are
online and/or reading pressure.