Twin Eagles Dine and Breakfast Club LP to NG Conversion - Manual (Page 3)

2
3. Top Burner Conversion
3-1) Check to make sure that you have the NG Gas Conversion Kit as follows:
a) PN 13313, Orifice, Defendi, 0.82 NG Center (2 pcs)
b) PN 13314, Orifice, Defendi 1.75 NG Outside (2 pcs)
3-2) Remove the burner cap, burner ring and burner hub to expose the burner base and
center orifice.
3-3) Remove the orifice cover plate to expose the outside orifice.
3-4) Remove the center orifice and outside orifice using a 7-mm. wrench.
3-5) Replace the orifices to Natural Gas as follows:
ORIFICE FROM LP GAS TO NATURAL GAS
Center 0.50mm (#76 DMS) 0.82mm (#67 DMS)
Outside 1.00mm (#61 DMS) 1.75mm (#50 DMS)
3-6) Make sure the regulator has been properly connected, replaced for Natural Gas
3-7) Check for leaks.
3-8) NEVER USE THE APPLIANCE WITHOUT FIRST LEAK TESTING THE GAS
CONNECTION.
a) Prepare a leak testing solution of sudsy water by mixing in a spray bottle
with half liquid soap and half water.
b) Confirm that all control knobs are in the “OFF” position.
c) Turn the main gas valve supply “ON”.
d) Apply leak testing solution by spraying on the pipe joints, fittings, and hose.
e) A gas leak is detected if;
i. there is a faint gas smell
ii. and/or growing bubbles appear on any of the connection points
and/or hose. DO NOT attempt to ignite the grill and IMMEDIATELY
turn off the gas supply valve.
f) When there is a gas leak, call a qualified service technician. DO NOT use
the grill until the leak is corrected.
3-9) Turn on burners. Set burners to low setting and check for burner flame height. If the
flames are too high for simmering or too low that they would not stay lit, adjust the
low flame setting.
3-10) To adjust low flame setting, pull out burner knob towards you. This will expose the
valve stem.
3-11) Insert a flat, skinny screw driver into the stem and turn the adjusting screw to the left
to increase the flame or to the right to decrease the flame. DO NOT OPEN THE
SCREW TOO MUCH: THE SCREW COULD FALL OFF THE STEM AND MAY
CAUSE GAS LEAK.
3-12) Fill up the Conversion Label. Next, paste it next to the original Serial Plate.
3-13) The conversion is complete and the unit is ready for installation. Refer back to the
Installation Manual.