TruTrak ADI User Manual
Page 11
Garmin 155XL/250XL/300XL
Garmin 155XL/250XL/300XL connections to TruTrak autopilot
J1 on
Garmin unit
Signal Name
(Garmin)
Signal Name
(TruTrak)
ADI
24
GPS RS 232 OUT 2
Primary Serial Input
6
Press and hold the MSG key and rotate the outer knob until the I/O setup page is displayed. Press CRSR twice and rotate inner knob
to select “plotting”. Rotate the outer knob to advance to the baud rate field. Use the inner knob and set to 9600. Press the CRSR to
finish and save
Note that for the Garmin units, the autopilot will need to be set for 9600 baud.
Garmin 430 and 530
Garmin 430 and 530 connections to TruTrak autopilot
P4001 [P5001] on
Garmin 430 [530]
Signal Name
(Garmin)
Signal Name
(TruTrak)
P101 on
TruTrak ADI/DII
56
GPS RS 232 OUT 1
Primary Serial Input
6/17
46
GPS ARINC 429 OUT A
ARINC-A
14
47
GPS ARINC 429 OUT B
ARINC-B
15
Power 430/530 up and turn it on while holding down the ENT key. Release the ENT key when the display activates. After the data
base pages, the first page displayed is the MAIN ARINC 429 CONFIG page. While in Configuration mode, pages can be selected
by ensuring the cursor is off and rotating the small right knob. To change data on the displayed Configuration Page, press the small
right knob (CRSR) to turn on the cursor. Turn the large right knob to change between data fields. Turn the large or small right knob
to change a field that the cursor is on. Once you have made the desired selection, press the ENT key to accept the entry.
With the MAIN ARINC 429 CONFIG page displayed, on the row labeled OUT, select SPEED Î Low
and DATA ÎARINC 429.
Advance to the MAIN RS232 CONFIG page.
On the row labeled CHNL1, select OUTPUT Î Aviation.
Note that for the Garmin units, the autopilot will need to be set for 9600 baud.
KMD 150
Power the KMD 150 up and turn it full bright. Press the MENU button then the SETUP button then the INST & DIAGS button then
the DATA IN/OUT. Change the DATA OUT PUT to NEMA 0183 the manual states the Baud rate is 9600. The output pin is pin 11
and connects to the Primary Serial input on the auto pilot controller.
You will need to match 9600 Baud rate in the auto pilot.
KMD 150 connections to TruTrak autopilot
37 Pin Connector
on KMD 150
Signal Name
Signal Name
(TruTrak)
P101 on
TruTrak ADI/ DII /Sorcerer
11
(AV NAV)
Primary Serial Input
6/17/25
TruTrak Flight System
9
ADI Flight Instrument Installation Manual
December
2009
8300-016
Rev
B