Trio Avionics Wing Servo Mount Installation for RV-4 and RV-6 - Manual (Page 4)

• The screws provided for the Gold
Standard servo crank arm are pre-coated
with a Loctite compound. These will hold
the crank arm securely.
• If you have a Gold Standard servo with
the crank arm already installed pointing
down, it will have to be removed. To avoid
stripping the screws when removing them,
heat the area with a heat gun to loosen
the Loctite before removing the screws/.
• Once the crank arm is installed, place the
washer over the shaft and install the cotter
pin as shown.
Step 4:
With the servo hub centered (crank pin in the hub facing straight up), install the
crank arm straight up as shown below..
Step 5:
Servo Installation in outer wing bay. (Right wing shown.)
• Remove wingtip to gain access to outer wing bay.
Step 6