Triner Scale T1000 Error Code - Manual (Page 7)

15 incorrect pin used 20 attempts at prepayment using incorrect PIN leads to permanent error code 15 display and machine
blocks. Every correct PIN input resets the counter to zero.
technicain:
Initialize
16 error postage registers
Postal registers R1 – R3 could not be corrected to make R1 + R2 = R3 a true statement. Permanent
error display and machine blocks if
a) R1 < R3 ... Correction possible. Error 16 deleted during new start
b) R1 > R3 ... Correction not possible. Permanent error 16 display
technicain:
17 Incorrect checking sum in the register
1...4. Incorrect checking sum in the register 1...4. Machine blocks and error code 17 is permanent.
technicain:
1. reset (initialize) machine and verify if error still occur
2. replace mainboard
18 NVRAM error Permanent error display and the machine blocks.
Data in the NVRAM are saved when:
a.) no action is undertaken with the machine for one minute (the display switches to stand-by, the clock
appears in the display left)
b.) during prepayment, or
c.) when power is shut OFF.
technicain:
Check NVRAM (Service computer);
Replace and initialize
19 Memory comparison error
(RAM & NV-RAM) Memory comparison error (RAM & NV-RAM) Department accounts, PIN, or machine number (each is
stored 3 times) cannot be automatically corrected. Permanent error code 19 and machine blocks.
technicain:
Initialization program incorrectly terminated?
Initialize
20 wrong pressure roller position The position of the pressure roller is not correct when the machine is turned ON. (Micro-switch
indicates roller not in at-rest position). The position is also checked after every franking operation.
Permanent error code and machine blocks.
technicain:
check micro-switch
check power supply
shaft with tooth wheel is broken?
Defect belt?
diagnostic-
code subcode1
subcode2 diagnostic message remedy
ISS international service support
email: [email protected]
created : 20.11.2007 19:31 Uhr
page 7 T1000