Triner Scale T1000 Error Code - Manual (Page 6)

10 29 Error cliché EPROM Cliché EPROM not present, defective, or incorrectly installed. IC- and socket markings do not agree or
IC contact legs make no contact.
Permanent Error code 10 and machine blocks.
Check components (all pins good contact, correct position, is it the right component?)
If a new cliché EPROM was just installed and the error is:
10 21, 10 22 or 10 29 indicates the EPROM or its contents do not match this type of machine.
10 2x Error cliché EPROM Cliché EPROM not present, defective, or incorrectly installed. IC- and socket markings do not agree or
IC contact legs make no contact.
Permanent Error code 10 and machine blocks.
Check components (all pins good contact, correct position, is it the right component?)
If a new cliché EPROM was just installed and the error is:
10 21, 10 22 or 10 29 indicates the EPROM or its contents do not match this type of machine.
11 hardware error memory µP - CPU Hardware error in processor memory. Machine blocks with permanent error code displayed.
technicain:
replacement of CPU // mainboard
12 read / write error RAM First beep phase is long. Machine cannot write into or read from RAM. Machine blocks with permanent
error code 12 displayed.
technicain:
1. Replace memory components and observe machine; If error repeats itself:
2. Replace MC board
13 Memory differences registers R1 - R4 Memory differences in Registers R1 - R4 (postal register) could not be corrected. Permanent error
code 13 displayed.
technicain:
1. Replace memory components and observe machine; If error repeats itself:
2. Replace MC board
14 write error RAM No RAM could be written
technicain:
1. Replace memory components and observe machine; If error repeats itself:
2. Replace MC board
diagnostic-
code subcode1
subcode2 diagnostic message remedy
ISS international service support
email: [email protected]
created : 20.11.2007 19:31 Uhr
page 6 T1000