Triner Scale TS60-1010 - Manual (Page 9)

Assembly Guide TS60-1010 Platform Scale
7
14) Bolt Down Both Ramps to the Concrete Floor
Using a hammer drill, drill 3/4” holes into the concrete for anchoring the floor mounting
tabs to the floor. Use the provided concrete anchors and securely fasten all four ramps
tabs to the floor.
15) Bolt Down the Four Deck Top Access Panels
Securely bolt down the access panels, lightly tightening the four corner bolts on the
panel, then working from side to side tightening the other bolts. Secrely tighten all bolts.
16) Bolt Down the Indicator Stand to the Concrete Floor
Using a hammer drill, drill four 1/2” holes into the concrete for anchoring the indicator
stand to the floor. Use the provided concrete anchors and securely fasten the indicator
stand to the floor.
Assembly of the scale is now complete, as shown in Fig. 11.