Triner Scale TS-20KD-1010 - Manual (Page 2)

Description
The Triner Scale Model TS-20KD-1010 Low Profile Cargo Scale with wrap around
ramps is designed for dependable daily use and precision built for year after year
accuracy. Only three inches high, it is designed to accommodate tugs, aircraft carts,
dollies, and pallet jacks.
Technical Specifications
Capacity: 20,000 lb x 10 lb
Platform Size: 10’ x 10’ (2 section)
Overall Height: 3”
Corner Capacity: 50 % of total capacity
Summing Junction: Signal trim summing card in NEMA 4x stainless steel enclosure
Load Cells:
Six 10,000 lb sheer beam type, 350 ohm, 3 mv/v
Required Installation Equipment
Tape measure
Heavy Hammer
Large pry bar
Hammer Drill
1/2" Concrete Hammer Drill Bit
1/4" Concrete Hammer Drill Bit
3/4" Deep well Socket with extension
1 1/8” Socket with Extension
Level
Cable tie wraps
Roll of tape
Calibration weights
Installation Procedure Outline
If there are any questions about the use or installation of the scale system, please call
800-238-0152.
1. Unpack and lay out all parts. Use the packing list included in this manual to verify
that all parts are accounted for. If any parts are damaged or missing please call
800-238-0152.
2. Refer to Figures 1, 2, and 3. Review the drawings carefully as they will help the
installation procedure go smoothly without unexpected problems.
3. Orient and install Platform Weldments #1 and #2.
4. Route load cell cables around the scale to a common exit point.
5. Orient and install the approach and side ramps.