Trending Accessibility Transitional & modern linear fusion shower pan on wood joists - Manual (Page 7)

Installation Guide
www.trendingaccessibility.com [email protected]
7
for linear shower pan on wood joists
Step 18
Just like you applied the corner pieces, use your
cut strips of Crack Insulation Tape to cover all the
seams. Again, trowel or paint liquid waterproofing
onto seam, press tape into position and coat the
top to seal. Make sure to fully cover both sides of
the crack isolation tape with the liquid waterproof-
ing product. To make this process more manage-
able, it is best to work in two foot sections.
NOTE:
Illustration just shows tape use.
Please apply liquid waterproof-
ing to the wall and tape before
applying.
Step 19
Using the 5” crack isolation tape. Overlap all seams
of cement board used on either the floors or walls.
Overlap the seam where the Linear Fusion pan and
cement board meet.
Make sure the tape
overlaps the seams
equally.
Extend the tape
2 feet past the
shower pan
2 feet
Step 20
Using the provided precut piece of gasket mem-
brane and modified latex thinset, apply thinset to
the area where gasket piece will adhered to the
drain area. Place over drain adapter flange, mak-
ing sure to cover all screw holes, and securely
press down into flange. Coat top of gasket piece
with liquid waterproofing.
Install the metal tiling guides now, following the
instructions in the drain box.
Gasket
Membrane
Step 17
Using the 5” crack isolation tape provided, cut
strips of tape to length, to cover all seams (Cor-
ner seams, wall/floor seams, pan/floor joint). Put
pieces aside.
If you are creating full wet room, you will need to tape
any seams throughout the entire room.
If you are only waterproofing the shower zone, you
will only need to tape the seams up to 2 feet outside
the shower area.