Traxxas 49104-1 - Manual (Page 8)

8 • T-MAXX
TRAXXAS TQ 2.4GHz RADIO SYSTEM
KA186 7-R00 KA186 7-R00
CH3 - Shifting Servo
CH2 - Throttle Servo
CH1 - Steering Servo
CH1 - Battery
Your model is equipped with the Traxxas TQ 2.4GHz transmitter. The transmitter has three channels: Channel one operates the steering,
channel two operates the throttle, and channel three operates shifting. The receiver inside the model has three output channels. Your
model is equipped with three servos and a receiver.
WIRING DIAGRAM
Antenna On/Off
Switch
Receiver
4-Cell
Battery Holder
Channel 1
Steering Servo
Channel 2
Throttle Servo
Channel 3
Shifting Servo
TQ 2.4GHz TRANSMITTER
Steering
Trim
Shifting
Switch
Throttle
Trigger
Steering Wheel
Power Switch Battery Compartment
Set Button
Red/Green Status LED
Applying The Decals
The main decals for your model
have been applied at the
factory. Additional decals are
printed on self-adhesive clear
mylar and are die-cut for easy
removal. Use a hobby knife
to lift the corner of a decal
and lift it from the backing.
To apply the decals, place one
end down, hold the other end
up, and gradually smooth the
decal down with your finger
as you go. This will prevent air
bubbles. Placing both ends of
the decal down and then trying
to smooth it out will result in
air pockets.
5
49104-1-KC2230-R00-T-Maxx-Operating.indd 8 10/30/14 5:10 PM