Touchstone 80004 Sideline Fireplace - Manual (Page 6)

5
OPERATING THE FIREPLACE
TO SWITCH UNIT ON
1. Plug in the appliance into the socket. Turn on the Power Switch
2. The control Switch Panel is under the Vent in front of the fireplace (See pic)
INSTRUCTION FOR REMOTE CONTROL AND SWITCH PANEL
Remote Control & Switch Panel
Power switch Plug in power cord; the fireplace is now on standby mode. Press the power button
once, the indicator lights up, Enjoy the view of the simulated charcoal lighting up and small flames in
dancing tempo. Press the same power button again and the flames go off. The Fireplace is on
standby mode again. Do not switch on fireplace when air outlets are blocked.
Heat Control Press this button once and indicator lights up. Ten seconds after the mechanism is
activated, warm air of 750W will be produced through the air outlets at the bottom. Press the same
button again and the indicator lights up. The air outlets will produce hot air of 1500W Press the same
button a third time, and the mechanism stops functioning after blowing out the remaining air in and shuts
off 10 seconds.
Power Switch
Control Switch Panel