Toa WM-5320H - Manual (Page 8)

133-07-267-7A
URL: http://www.toa.jp/
Main unit
Modulation
Frequency modulation
Frequency Range 636 – 698 MHz, UHF
Selectable Channel 64 frequencies (the number of channels may differ from country to country.)
RF Carrier Power Less than 50 mW
Tone Frequency 32.768 kHz
Oscillator PLL synthesized
Maximum Input Level 120 dB SPL
Battery LR6 (AA)
Battery Life More than 10 hours (alkaline)
Indicator Power/Battery lamps
Antenna Built-in type
Operating Temperature –10 to +50°C
Finish Resin, coating
Dimensions 62 (w) x 102.5 (h) x 23 (d) mm
Weight 90 g (with battery)
Headset
Microphone Element
Electret type, cardioid pattern
Cable Length 1.4 m
Connector ø3.5 mm mini-plug
[WM-5320A, WM-5320H]
Note: The design and specifications are subject to change without notice for improvement.
• Accessories
Microphone Element Electret condenser type, omni-directional pattern
Modulation Frequency modulation
Frequency Range 636 – 698 MHz, UHF
Selectable Channel 64 frequencies (the number of channels may differ from country to country.)
RF Carrier Power Less than 50 mW
Tone Frequency 32.768 kHz
Oscillator PLL synthesized
Maximum Input Level 110 dB SPL (Audio level control: Maximum position)
Battery LR6 (AA)
Battery Life More than 10 hours (alkaline)
Indicator Power/Battery lamps
Antenna Built-in type
Operating Temperature –10 to +50°C
Finish Resin, coating
Dimensions 62 (w) x 102.5 (h) x 23 (d) mm
Weight 110 g (with battery)
Note: The design and specifications are subject to change without notice for improvement.
• Accessories
12. SPECIFICATIONS
[WM-5320]
Screwdriver (for setting) .................................... 1
Storage case ..................................................... 1 Neck strap ......................................................... 1
Screwdriver (for setting) .................................... 1
Waist pouch (WM-5320A only) ......................... 1 Neck strap (WM-5320H only) ............................ 1
License requirement
The term "IC:" before the radio certification number only signifies that Industry Canada Technical
specifications were met. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the
antenna or the device is permitted. Any change to the antenna or the device could result
in the device exceeding the RF exposure requirements and void user's authority to
operate the device.