Toa YW-4500 - Manual (Page 3)

3
Step 3. Strip coaxial cable end.
• RG-6/U
• RG-11/U
Step 2. Detach the top case from the bottom case.
• If the coaxial cable is wired over the wall from the
ceiling or floor
1. Cut the cable outlet of the frame using a pair of
cutting pliers, etc.
3. Run the coaxial cable through the cable outlet.
Cable outlet
Attenuator switch
Bottom case
Top case
5. INSTALLATION
Unit: mm
ø20
13
10 3 12 Jacket
Conductor
Braided shield
Dielectric
Unknit braided shields
and bend it back.
Braided shield
Braided shield
Conductor
13
10 3
• If the coaxial cable is to be drawn directly from the
wall surface
1. Drill a ø20 mm hole.
2. Run the coaxial cable through the hole and the
bottom case as well, and draw it out as shown below.
• If the coaxial cable is installed using a recessed
electrical box (Mounting pitch: 83.5 mm)
Draw out the coaxial cable through the electrical box
and the bottom case.
Note: Be sure to use a pipe thick enough to allow the
wired coaxial cable to be easily inserted.
Step 1. Remove 4 screws on the top case.
2. Cut the supplied rubber bushing into halves. One
half is suited for the RG-6U cable (smaller internal
diameter) and other half for the RG-11/U cable
(larger internal diameter). Run the cable through
the bushing. (Insert the bushing into the cable entry
hole after cable installation completion.)
Rubber bushing