Toa WT-5810 - Manual (Page 8)

8
Power Source AC mains (Supplied AC adapter must be used)
Power Consumption 130 mA (12 V DC)
Receiving Frequency 576 – 865 MHz (576 – 606 MHz and 614 – 698 MHz for USA/Canada)
Channel Selectable 16 channels
Receiving System Double super-heterodyne
Diversity System Space diversity
Mixing Output MIC: –60 dB*, 600 Ω, balanced, XLR-3-32 type connector
LINE: –20 dB*, 600 Ω, unbalanced, phone jack
Mixing Input –20 dB*, 10 kΩ, unbalanced, phone jack
Antenna Whip antenna
Receiving Sensitivity 90 dB or more, Signal to Noise ratio (20 dBμV input, 40 kHz deviation)
Squelch Sensitivity 16 – 40 dBμV variable
Squelch System Using together of noise SQ, carrier SQ and tone SQ
Tone Frequency 32.768 kHz
Indicator ANT A/B, Audio (peak), Battery alarm, Channel number
Channel Check Usable frequencies scanning
Signal to Noise Ratio 104 dB or more (A-weight, unbalanced output)
Harmonic Distortion 1% or less (typical)
Frequency Response 100 Hz – 15 kHz, ±3 dB
Operating Temperature –10°C to +50°C (14°F to 122°F)
Operating Humidity 30 % to 85 %RH
Finish Resin, black
Dimensions 206 (w) x 40.6 (h) x 152.7 (d) mm (8.11" x 1.6" x 6.01") (excluding antenna)
Weight 590 g (1.3 lb)
9. SPECIFICATIONS
* 0 dB = 1 V
Note: The design and specifications are subject to change without notice for improvement.
• Accessory
AC adapter ................................................. 1
8.4. Channel Detection
Step 1. Press the Set key and the Next key at the same time for over a second.
Channel detection begins, and an idle channel number is indicated blinking on the channel number
display.
Step 2. Press the Next key to select the channel.
Step 3. To set the channel to the unit, press the Set key for over a second until the blinking number turns to
steady light.