Toa WT-5810 - Manual (Page 6)

6
8. HOW TO CHECK AND DEAL WITH INTERFERENCE
8.1. Order of Actions (Action Flowchart)
Pressing RF check key, check signal
condition of the channel.
[No]
Any
interference?
[Yes]
[No]
Any
interference?
[Yes]
[No]
Any
interference?
[Yes]
Change to idle channel.
Pressing RF check key, check signal
condition of the channel.
Adjust squelch to limit transmission distance.
Contact shop from where unit was
purchased.
Refer to p. 7 "8.2. Checking Ambient Signal
Condition."
Refer to p. 7 "8.3. Reducing Radio Interference
by the Squelch Control."
Use as is.
Refer to p. 6 "7. CHANNEL NUMBER SETTING."
Use as is.
Use as is.
7. CHANNEL NUMBER SETTING
Step 1. Press the Set key for about a second until the displayed channel number blinks.
Step 2. Select the desired channel number with the NEXT key, and press the Set key for about a second until
the blinking number turns to steady light.
Tip
Continuous or each depression of the NEXT key permits the display to cycle through the channel numbers.
1 2 Channel number display