Toa MT-200 - Manual (Page 2)

3. DIMENSIONAL DIAGRAM
[Top]
[Front]
[Bottom]
[Side]
69.9
(2.75)
69.9
(2.75)
129 (5.08)
4-22 x 12 (0.87 x 0.47) 4-ø9 (0.35)
111 (4.37)
164 (6.46)
140 (5.51)
111 (4.37)
123 (4.84) 99 (3.9)
35 (1.38) 18.5 (0.73)
18.5 (0.73)
42 (1.65)
2 (0.08)
141 (5.55)
80
(3.15)
60 cm (1.97 ft) long
(Primary and secondary)
Cover
Unit: mm (in)
5. MATCHING TRANSFORMER INSTALLATION
Bolts can be tightened using either a Phillips screwdriver or a wrench, but
be sure to finish the tightening with the wrench to ensure optimum
tightness. Failure to do this could cause the speaker to fall, potentially
resulting in damage and/or personal injury.
WARNING
4. SPECIFICATIONS
* Every speaker module must be aimed horizontally or down to keep the water resistant capability.
Note: The design and specifications are subject to change without notice for improvement.
• Accessories
Hexagon head bolt M8 x 15 (with washers) ......... 2
Rated Input 200 W
Primary Impedance 100 V line: 50 Ω (200 W), 83 Ω (120 W), 167 Ω (60 W)
70 V line: 25 Ω (200 W), 50 Ω (100 W), 83 Ω (60 W), 167 Ω (30 W)
Secondary Impedance 8 Ω
Water Protection IPX4 (the tilt angle must be within 45°)*
Finish Cover: Polypropylene
Mounting bracket: Stainless steel (SUS304)
Dimensions 164 (w) x 141 (h) x 129 (d) mm (6.46" x 5.55" x 5.08")
Weight 2.8 kg (6.17 lb)
5.1. Mounting to the HX-5 Series Speaker System
Note
When the matching transformer is installed on the HX-5 series Speaker System, the optional HY-WM1 series
and HY-CW1 series Speaker Mounting Brackets, and HY-ST1 Speaker Stand Adapter cannot be used.