Toa WT-2100 - Manual (Page 3)

8.1 Holder
Raise the holder's tab to detach.
To attach, push the holder till it fits onto the unit with
a click.
8.2 Neck Strap
When attaching the neck strap, remove the holder,
then fit the strap as shown in the figure.
7. HINTS ON OPERATION
• Up to 5 different channels can be simultaneously used in the same location. (Note that communication
distances may be shortened by simultaneously using 2 or more channels compared to use of only a single
channel.)
8. HOW TO DETACH AND ATTACH THE HOLDER AND NECK STRAP
6. OPERATION
Step 1. Remove the battery cover and place the battery as shown below. (Ensure that the Power/volume
switch is set to the OFF position.)
Step 2. Replace the battery cover and securely lock it .
Step 3. Set the Channel selector switch to the same channel as the transmitter.
Step 4. Connect an optional earphone to the Earphone output terminal and put the earphone on the ear.
Step 5. Switch on the power by turning the Power/volume switch clockwise, and adjust the volume.
The Operation/battery indicator either lights or flashes when the power is turned on.
Step 6. Turn off the power after use.
[Operation/battery indicator-to-WT-2100 Relationship]
Unlock the battery cover
to remove.
Place the battery.
Indicator WT-2100
Flashes slowly. Standby mode (no signal reception)
Steadily on Receiving a signal.
Changed from green to red. Battery has been exhausted.
Neck strap
Holder
(back side)