TeeJet FieldPilot Install Miller Condor - Manual (Page 15)

13
FieldPilot ®
98-05160 R2
7. install steering hoses and adaPters
Disconnect the steering hoses from the outside ports of the steering cylinders (both left and right). Install run
tee (O) to each of the cylinders. Reconnect the steering hoses to the run of the run tee (O) . Connect the 90°
end of hose (M) to the branch of the run tee (O) of the left cylinder and connect the 90° end of the other hose
(M) to the right cylinder. Route hoses (M) to the FieldPilot valve. Be sure to leave enough hose slack to allow
for possible wheel width adjustment. Connect hoses (M) to the A and B ports of the FieldPilot Valve. Do not be
concerned about which hose goes to which port on the FieldPilot valve.
Figure 1-11: Install Steering Hoses and Adapters
M
o
M
M
M
o