TC-Helicon VoiceTone Create Manual - Manual (Page 17)

17
Sound Engineer Setup
If you are in a situation where a live sound engineer
mixes your vocal sound, you have the option of giving
them control over your wet/dry mix. In this
configuration the live sound engineer will have one
channel on their mixing console with your dry vocal, and
the other channel with the fully wet mono effects.They
can mix between the two to get the desired effect
balance.
Configuring Sound Engineer Setup:
1. Connect your microphone to Create's Mic Input.
2. Connect to your sound system as indicated: Left
and Right Outputs to two mic inputs on your sound
system. Set your sound system’s pan pots to center.
3. Connect Create's power adapter to main power
and to the Power Input on Create.
4. Confirm that stereo mode is off. If the Stereo Light
is on, press and hold Performance Buttons 4 and 5
simultaneously until the Stereo Light turns off.
5. Turn the Mix Knob fully right. In this configuration,
the sound engineer will have access to your dry voice on
the Right Output, and your fully effected voice on the
Left Output.
Setup Configurations