TC-Helicon VoiceLive Touch User Manual - Manual (Page 17)

A
DDITIONAL
S
ETUP
M
ENUS
In addition to the Setup menu described previously are the MIDI and
Advanced menus. Hold the Mix button to enter the most recently used
of these menus. Hold the right arrow button to cycle to the next menu
or hold the left arrow to cycle to the previous menu.The current menu
name will show for a moment before changing to a parameter in that
menu and showing it’s value. The MIDI and Advanced menus are
discussed below.
T HE MIDI S ETUP M ENU
The MIDI setup menu allows you to adjust settings relating to control of
VoiceLive Touch from a MIDI keyboard or a sequencer. See above for
instructions on accessing the MIDI setup menu.
1 MIDI Chan - Sets the MIDI channel on which Touch will receive the
MIDI notes for harmony control in Notes presets and program change
messages that call up presets or Favorites. A setting of Off will prevent
these messages from being received on any channel.
2 Filter - Blocks program change (PrgChange), system exclusive (Sysex)
or both (PC+Sysex) messages. It can be convenient to block program
change messages if your keyboard controller is sending notes and
program changes to a sound module on the same channel and you want
VoiceLive Touch to receive only notes. Sysex can be filtered to prevent
presets being overwritten by an external program such as VoiceSupport.
3 CC Chan - Sets the MIDI channel on which Touch can receive
continuous controller (CC) messages such as volume (CC7). By default,
this is set to channel 1 but it can be changed to other values including
0ff which will ignore all CC messages on all channels.
4 Transpose - This transposes the harmony voices in MIDI Notes presets
to allow it to be controlled by upper or lower sections of a MIDI
keyboard if required.The value corresponds to octaves.
5 SplitDir - (Split Direction) Sets whether MIDI notes ABOVE or
BELOW the split point are used to control MIDI Notes presets only.
6 SplitNote - Sets the MIDI note above or below which the keyboard
split will be active.
7 SysexID - (MIDI System Exclusive ID number) Used when addressing
multiple VoiceLive Touch units with a MIDI editing program. If multiple
units are on the same MIDI In/Thru chain, each one should have its own
ID or they all will be edited in the same way.
8 VibBoost - Specifies how the Mod Wheel message affects vibrato if it
is enabled in a preset.The Boost setting (default) will add more vibrato
once the part of the wheel movement reaches the corresponding
amount of vibrato and then returns to the original amount at rest
position.The Manual setting allows full range control of vibrato once the
wheel is moved.To restore the factory vibrato amount, recall the preset.
9 PBRange - (Pitchbend Range) Sets the range in semitones that MIDI
pitch bend information will alter harmony voice pitch shifts.
10 MIDI Ctrl - Specifies through which input MIDI notes and sysex data
are received: the physical MIDI input or the USB input:
MIDI Setup Menu
18