TC-Helicon VoiceTone T1 Manual - Manual (Page 7)

First Setup and Use
1. Turn down your PA’s master volume and set the desired input channel EQ to flat (EQ=off).
2. Connect your mic and PA as shown in the diagram first, then plug in the AC adaptor. For live
performance, a USB connection to a computer is not required.
3. Set the Shape and Comp / De-ess controls to the center notch. Turn Warmth off if is isn’t already.
4. Sing into your mic while adjusting the MIC GAIN control so that the input level LED flashes green.
Brief flashes of red on the LED on your loudest singing are ok.
5. Ensure that the effect is on (center LED is lit).
6. Sing while turning up your PA volume to a comfortable level.
VoiceTone T1 will take a moment to adjust to the tone of your voice. It constantly adjusts as you sing.
You will notice your voice is pleasantly brighter and smoother.
Phantom Power
There is no switch to enable phantom power on the VoiceTone singles. Phantom power is available
when the product is powered. Microphones that don’t require phantom power will operate properly.
Always apply power as the last connection step and ensure your PA is muted. This will reduce the
chance of audio crackles that could harm your equipment.