SUUNTO SMART BELT - Manual (Page 4)

4
SIGNALS
The LED colors have the following meaning:
• Green light = normal operation
• Orange light = memory low or full
• Red light = battery low or empty
The beeps and color LED flashes indicating different states of Suunto Smart Belt are
described in the following table. The symbols in the beep and flash columns indicate the
length of the signal (short, medium-length or long).
NOTE: Suunto Smart Belt can give two long beeps for three different reasons. In this case,
check the color of the flash to find out the correct cause.
BEEP FLASH DESCRIPTION
(green) Successful operation:
•
Activated, starts recording
• Connected to PC
• New battery installed successfully
(green, every 4 seconds) Measuring and recording
(green) No heart rate detected for 30 seconds
(green) Belt goes into sleep mode
Belt disconnected from PC
(3 times) 3 times, then 1 every
4 seconds (orange) Memory low, still recording
(orange) Memory full, switching to sleep mode
(3 times) 3 times, then 1 every
4 seconds (red) Battery low, still recording and transmitting
(red) Battery too low to operate, switching to sleep
mode (this applies also to PC connection)