SUUNTO GPS POD User Manual

Page 7

2. Replace the AAA size (LR03) batteries, set the bottom cover over the top cover and

close the POD by turning the bottom cover right (clockwise).

2.6. SUUNTO TRAINING MANAGER

You can transfer the speed and distance data recorded by your wrist unit to your computer

to be viewed in the Suunto Training Manager PC Software (Suunto t6) or Suunto Training

Manager Lite (Suunto t3 and t4, optional with PC POD).

2.7. TROUBLESHOOTING

Wrist unit does not find the POD:

• Ensure the POD is on (green light flashing).
• Replace the battery (red light flashing or no light after activation).
• Pair the POD if not paired yet.

Wrist unit does not show speed and distance:

• Ensure that the POD is on.
• Ensure that the POD is receiving satellites (green light flashing 1/s).
• Reconnect the wrist unit to the POD (“Connect” with the Suunto t6, exit and re-

enter the Training or Speed and Distance mode with the Suunto t3 or t4).

• Improve the placement of the POD so that the top cover faces directly to the sky.
• Ensure that the signal from the POD to the wrist unit is not blocked by your body,

arm or wrist. There should be a direct line of sight from the POD to the wrist unit.

NOTE! Buildings, terrain, or even dense foliage can block signal reception. GPS will not

work indoors.
NOTE! GPS based speed measurement is not accurate at low speeds (< 4 km/h / 2.5mph).

The speed reading is also less accurate if the satellite signal is low, e.g. in a forest.
Pace measurement reading (units min/km and min/mile) may appear to vary more than true

speed at a pace slower than 7.5 min/km (12 min/mile) due to the nature of the measure-

ment unit.