SUUNTO DX - Manual (Page 45)

When the dive computer is in the permanent Error mode, only the Er warning is shown
in the center window. The dive computer does not show times for ascent or stops.
However, all the other displays function as before to provide information for ascent.
On an intended no-deco dive, you should immediately ascend to a depth of 3 to 6
m/10 to 20 ft and remain at this depth until air supply limitations require you to surface.
On a planned deco dive you should utilize your back-up plan and proceed with the
dive according to the plan, available gases allowing.
After surfacing, you should not dive for a minimum of 48 hours. During the permanent
Error mode, the Er text is displayed in the center window and the planning mode is
disabled.
5.6. Wireless transmission
In order to use the transmitter, the wireless integration needs to be enabled in your
Suunto DX settings. To enable or disable the wireless integration, refer to Section 5.8.5.
Setting the tank pressure pairing.
5.6.1. Installing the wireless transmitter
When purchasing the Suunto wireless transmitter, we strongly recommend that you
have your Suunto representative attach the transmitter to the first stage of your regu-
lator.
However, if you decide to attach it yourself, do the following:
1.
Remove the high pressure (HP) port plug on the first stage of your regulator using
an appropriate tool.
46