SUUNTO BIKE POD - Manual (Page 4)

NOTE: To reduce the risk of fire or burns, do not crush, puncture or dispose of
used batteries in fire or water. The POD uses one CR2032 battery. Only use this
kind of battery. Recycle or dispose of used batteries properly.
3. USING YOUR BIKE POD
There are two different Suunto Bike PODs available. The universal Suunto Bike
POD is ideal for all situations, and attaches easily to all kinds of bikes. The
Suunto Road Bike POD has a quick-release system and also fits on most kinds
of bikes, although it is especially valued as a road-cycling Bike POD.
3.1. ATTACHING THE UNIVERSAL SUUNTO BIKE POD
3.1.1. CONTENT OF THE UNIVERSAL SUUNTO BIKE POD PACKAGE
• Bike POD (1)
• Magnet (2)
• 2 wire ties (3)
• Holder for the wristop computer (4)
3.1.2. INSTALLING THE MAGNET BRACKET
Place the magnet bracket on a spoke on the right side of the wheel. The magnet
must be turned towards the Bike POD.
Note: If you are using a wheel with extra flat spokes, you need to cut the tabs on
the magnet bracket beforehand.
3.1.3. INSTALLING THE BIKE POD
1. Insert a wire tie into each slot designed for this purpose from the Bike POD
side. The head of the wire tie must go in its slot as far as possible.
2. Place the Bike POD on the right blade of the fork (the Bike POD must be
pointing forward); close the fixing collars without tightening them.
3. Adjust the position of the Bike POD so the center of the magnet is aligned
with one of the arrows on the Bike POD. The distance between the magnet
and the Bike POD must be less than 10 mm.
CR 2032