ClearSounds V508 - Manual (Page 7)

6 – ENGLISH 7 – ENGLISH
upper and lower key hole slots on the back of the phone. Slowly slide
the phone down until it snaps into place.
6 Connect the handset coil cord (curly cord) to the handset and to the
telephone.
7 Attach the AC power Adapter to the back of the phone and plug the other
end into a working electrical outlet (not controlled by a wall switch).
8 Lift the handset and listen for a dial tone. If you hear a dial tone, your
phone is ready to use. If there is no dial tone, check all your cords to
make sure they are plugged in securely.
SettInG up pHone
BaSIC funCtIonS
Setting the Dialing mode
Set the dial mode switch on the bottom of the phone to “T” if you have Touch
Tone service, or “p” for pulse dialing if you have rotary dialing service. The
default is set to the “T” dialing switch mode.
redial function
This feature allows you to redial the last number you have called by
one-touch operation.
1 Lift the handset or press the SpEAKER button to get a dial tone.
2 press the REDIAL button to redial the last number called.
flash function
press the CALL WAITING button to end a call and get a dial tone for another
call or to switch to another call from “call waiting”.
NoTE: You must subscribe to Call Waiting Service from your local phone
company. If you do not subscribe to Call Waiting, pressing the CALL WAITING
button during a call may disconnect your current call.
Speakerphone
Making A Call Using The Speakerphone
1 press the SpEAKER button for dial tone.
2 Adjust the volume to fit your needs. Move the Speaker Volume
Adjustment Switch located to the side of the telephone.
3 To dial a number you can:
a Dial a number from the keypad
b press one of the priority or Memory dial buttons
c Dial from your phone Book or Caller ID
CSC-600-TriLingual.indd 7 6/2/08 1:38:33 PM