Sure Heat 2008 Four Seasons FSIS Natural Gas Conversion Kit - Manual (Page 5)

16. Reattach the flex lines to the rear IR burner valve,
bottom IR burner valve and side burner valve. (See
Fig. 16)
Note: Be careful, applying pressure to the elbow of
the valves may cause them to break.
17. Slide the front control panel back in position. Make sure
the orifices of the main burner control valves insert into
the main burner tubes. (See Fig. 17)
18. Use the four screws removed in step 4-5 to secure the
front control panel in position. (See Fig. 18)
19. Remove the bread warming rack, main cooking grates,
flavor grids and set them aside. (See Fig. 19)
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Fig. 15
FSISLP Natural Gas Conversion Instructions
15. Place the front control panel back onto the grill and hold
it. Feed the two igniter wires through the hole on the
grill head bottom into the grill cabinet. Reconnect the
wires to the two outstand terminal tabs on the igniter
module. (See Fig. 15)
Igniter wires
Rear IR burner
flex line
Bottom IR
burner flex line
Side burner
flex line
Valve orifice
Main burner
tube
Inside view underneath the front control panel