Sure Heat Altima 30, 38, 48 - Manual (Page 21)

USING THE ROTISSERIE BURNER
Rotisserie Lighting
Open the lid. Push and turn the control knob a 1/4
turn to the left, then push in the safety knob located
directly above the Infrared control knob. While hold-
ing in the safety knob, press and hold the electronic
ignitor button. You’ll hear a snapping sound. If the
burner does not light in 4 seconds, turn the control
knob to the “OFF” position and wait 5 minutes before
trying again. Once lit, it is necessary to hold in the
safety knob for about 20 seconds to allow the thermo-
couple to heat up. After 20 seconds, release the safe-
ty knob and turn the control knob to the desired set-
ting. (See Fig. 18)
(If the ignitor does not function, the burner can be lit
by holding a lit match to the burner while the control
knob is turned a 1/4 turn to the left and the safety
knob is pressed in.) (See. Fig. 19)
After the first use the stainless steel around the burner
will darken. This is a normal occurrence of the non-
rusting, type 304 stainless steel used on the grill. The
infrared panel will also darken after initial use. This
is a normal occurrence.
Note: Do Not operate the main burners and back
infrared burners at the same time.
19
Fig. 18
Fig. 19