Sure Heat 2008 Amana AM33 - Manual (Page 34)

Using Your Outdoor Grill (cont.)
Using Your Rotisserie Burner
The grill rotisserie burner is designed to cook items from the back using infrared heat. The rotisserie
burner is an infrared type which provides intense searing radiant heat. Preferred by chefs over other
cooking methods, this intense heat sears in the natural juices and nutrients found in quality cuts of
meats.
NOTE: The rotisserie spit rod is centered between the grill hood and the burners. It may be
necessary to remove the grates and flavor grids when cooking larger portions of meat on the
rotisserie. This is by design, since this configuration gives you the most possible room
above and below the rod for larger pieces of meat.
Once lit, the rotisserie burner will reach cooking temperature in 1 minute. The orange/red glow will
even out in about 5 minutes. The rotisserie motor is equipped with metal gears and is capable of
turning up to 12 lbs. of food. The motor is mounted on a bracket on the left side of the grill by sliding
the motor over the bracket with the cord facing the back of the grill. Make sure the rotisserie motor is
completely seated on the bracket prior to operating. Make sure the rotisserie cord is away from any
hot surfaces.
Note: The rotisserie kit is not included and sell seperately.
Lighting the Rotisserie Burner
1. Open the hood completely. Do not light burners with the hood closed.
2. Remove the warming rack from the grill when using the rotisserie to prevent warping from the
intense heat of the infrared unit.
3. Do not lean over the grill.
4. Push in and turn the control knob to ON and immediately press the electronic igniter button.
5. You will hear the “snapping” sound of the spark igniter. When burner is lit, release the knob.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF and wait 5 minutes before
relighting.
Manually Lighting the Rotisserie Burner
1. Do not lean over the grill.
2. Remove the manual lighting extension and attach a match to the split ring.
3. Strike the match to light it.
4. Guide the match to the burner.
5. Push in and turn the burner knob to ON. The burner will light immediately.
6. Remove match and replace manual lighting extension.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF and wait 5 minutes before
relighting.
If any burners do not light after attempting to light them manually, contact customer service.
See the “Assistance or Service” section.
OUTDOOR GRILL USE
34
Remove the warming rack from the grill when using the rotisserie to prevent warp-
ing from the intense heat of the infrared unit.