SunBriteTV SB-5517HD - Manual (Page 15)

SunBriteTV Model 4717HD and 5517HD Operator’s Manual Page 15
TV Installation – Rear Panel Connection Diagrams
CONNECTING TO A SATELLITE OR CABLE SET-TOP BOX (Continued)
1. Make sure the power of the TV and your DVD player is
turned off.
2. Obtain an S-Video Cable. Connect the S-Video connector
to both your DVD player and Composite’s S-Video
connector port off the back of your TV.
3. Obtain a RCA Audio Cable. Connect the white color
connector to both your DVD player and Composite’s
white connector port off the back of your TV.
4. Connect the red color connector to both your DVD player
and Composite’s red connector port off the back of your
TV.
5. Turn on the TV and your DVD player.
6. Use the remote control’s source button or the source
button on the right side of the TV to switch to AV1
(S-Video).
Please Note :
1. If AV 1 is already occupied, use AV 2 as your connection
port and switch source to AV 2 (S-Video).
2. Refer to the set-top box’s manual to make sure the set-top
box is configured to output correctly to the TV.
3. This model supports SONY’s universal remote code. If
SunBriteTV is not listed, please look up SONY’s codes in
your universal remote’s hand book.
4. This TV will turn off automatically if there’s no signal
present for more than 15 minutes.
1. Make sure the power of the TV and your DVD player is
turned off.
2. Obtain a Yellow Video Cable. Connect the Yellow Video
connector to both your DVD player and Composite’s Yellow
Video connector port off the back of your TV.
3. Connect the white color connector to both your DVD player
and Composite’s white connector port off the back of your
TV.
4. Connect the red color connector to both your DVD player
and Composite’s red connector port off the back of your TV.
5. Turn on the TV and your DVD player.
6. Use the remote control’s source button or the source button
on the right side of the TV to switch to AV1 (CVBS).
Please Note :
1. If AV 1 is already occupied, use AV 2 as your connection port
and switch source to AV 2 (S-Video).
2. Refer to the set-top box’s manual to make sure the set-top
box is configured to output correctly to the TV.
3. This model supports SONY’s universal remote code. If
SunBriteTV is not listed, please look up SONY’s codes in your
universal remote’s hand book.
4. This TV will turn off automatically if there’s no signal present
for more than 15 minutes.
Connecting with S-Video (Fair)
Connecting with
Composite (Fair)