Studio Electronics Boomstar Modular - Manual (Page 16)

3003 Filter Module - 2
All Controls and Patch Points
FREQUENCY – Adjusts the frequency, or cut-off of the filter.
RESONANCE – Adjusts the resonance of the filter. *
FULL HALF TRACK – Switch between full and half keyboard/voltage tracking.
FREQ CV 1 – Frequency control voltage 1 input attenuverters.
RESO CV – Resonance control voltage input attenuverters.
FREQ CV 2 – Frequency control voltage 2 input attenuverters.
INPUT – Adjusts the audio input.
OUTPUT – Adjusts the audio output.
1 V/O – One volt per octave control voltage input.
FREQ CV 1 – Frequency control voltage 1 input.
FREQ CV 2 – Frequency control voltage 2 input—get tricky with the second attempt.
RESO CV – Resonance control voltage input—use for shimmers or howling wolf tones.
INPUT – Audio input.
2x OUTPUT – Audio outputs.
!
* From 7:00 (0) to 9:00 our “Negative Resonance Saturation” adds beefiness, boosting the waveform amplitude and taming
waveform transients; set to 9:00 to achieve the cleanest tone possible.
13
AMP 4075 5089 3003
DRIVE
ST 1/2
OUTPUT ST 2/2 ST 2/1
ST 1/1 INPUT
INPUT
OUTPUT
STAGE 2/2
STAGE 1/2
DRONE
FULL
INPUT
1 V/O FREQ CV 1 FREQ CV 2 RESO CV
OUTPUT OUTPUT
FREQUENCY
FREQ CV 1
INPUT OUTPUT
FREQ CV 2
RESO CV
RESONANCE
HALF
TRACK
FULL
INPUT
1 V/O FREQ CV 1 FREQ CV 2 RESO CV
OUTPUT OUTPUT
FREQUENCY
FREQ CV 1
INPUT OUTPUT
FREQ CV 2
RESO CV
RESONANCE
HALF
TRACK
INPUT
1 V/O FREQ CV 1 FREQ CV 2 RESO CV
OUTPUT OUTPUT
FREQUENCY
FREQ CV 1
INPUT OUTPUT
FREQ CV 2
RESO CV
RESONANCE
HALF
TRACK