Modulation, Knobs, Switches – Studio Electronics C.O.D.E. User Manual

Page 8

Modulation destinations for modwheel, dynamics, and pressure:

FRE1 - osc 1 frequency

FRE2 - osc 2 frequency

1&2F - osc 1&2 frequency

LEV1 - osc 1 level

LEV2 - osc 2 level

PW1 - osc 1 pulse width

PW2 - osc 2 pulse width

1&2P - osc 1&2 pulse width FILT - filter frequency

RESO - filter resonance

LEVN - noise level

XMOD - xmod depth

EA1 - envelope 1 amount

EA3 - envelope 3 amount

EXT - external input mix level

LF1R - LFO 1 rate

LF2R - LFO2 rate

LF1D - LFO 1 depth

LF2D - LFO 2 depth

1&2D - LFO 1&2 depth 1&2R - LFO 1&2 rate

PAND - pan depth

PANR - pan rate

PAN - pan position

Modulation

Knobs

rate x2: rate of LFO.
depth x2: depth of LFO. Front panel knob controls amount of destination 1 only. You can also
use the Q dial to edit this parameter as well. Value is displayed on LFO edit page 1. Depths for
destinations two and three are done via the Q dial.
depth (xmod): depth of oscillator 2 frequency modulating oscillator 1 or filter frequency.

Each LFO can modulate up to three different destinations. If a same destination is selected in
more than one location, the location furthest left will override and determine the ultimate depth.

NOTE: Destinations 1&2 are assignable to midi controllers, destination is 3 is modulated by envelope 3.

Switches

LFO edit (Both LFO 1 and LFO 2 edit pages are the same.)
page 1: destination assignments and amounts.
page 2: [WAVE] waveform, [MODE] mono or polyphonic, [SYNC] midi clock synch times.
page 3: [KEY] key trigger modes, [QUAN] quantized LFO modulation.

Xmod: selects the destination for oscillator 2 audio frequency modulation. The front panel LEDS
will indicate the routing.

Modulation destinations for LFO 1 and 2:
FRE1 - osc 1 frequency