StarTech.com ST521PMINT - Manual (Page 7)

Instruction Manual
4
3. Drive the screws through the bracket holes on the ST521PMINT into the mounting
holes on your desired bracket using the small Philips head screw driver.
4. Your desired bracket has now been installed.
System Installation
Note: The SATA controller that the ST521PMINT is connected to must support Port
Multiplier.
1. Open your computer case (refer to the computer case user manual for details), and
place the ST521PMINT into an available expansion slot.
2. Using a computer case screw (not included) and the appropriate corresponding
screw driver (not included), drive the screw into the computer case through the case
mounting hole on the mounting bracket (refer to the computer case user manual
for details).
3. Connect the included SATA cable from your motherboard to the Host computer
SATA connection port on the ST521PMINT.