StarTech.com SAT32M225 User Manual

Page 7

Instruction Manual

4. Using a Phillips head screw driver (not included). Remove the screw located in the

front of the hard drive installation bracket.

Note: There are screws located on either side of the bracket, ensure the front screw

is the one removed, see photo below.

5. Slide the M.2 connector on the SSD into the M.2 receprical connector on the

SAT32M225.

Note: The connector on your M.2 SSD is keyed so the drive will only fit one way.

6. Press the drive down toward the drive mounting bracket, and drive the removed

screw through the mounting hole on your SSD drive and into the drive mounting

bracket using a Philips head screw driver.