StarTech.com IES51000 - Manual (Page 6)

Instruction Manual
3
DIP Switch Settings
Installation
The Network Switch is designed to sit on a flat surface, or be securely mounted to
either a wall or DIN-Rail using the included brackets. Please follow the instructions
below, depending on your preferred installation.
Wall Mounting
1. Attach the Wall-mount brackets to either the rear, or the side of the switch,
depending on your desired orientation.
Pin # Position Status
Pin 1
ON Enable power alarm
OFF Disable power alarm
Pin 2
ON Enable broadcast storm rate limit
OFF Disable broadcast storm rate limit
Pin 3
ON NOT USED
OFF NOT USED
Pin 4
ON NOT USED
OFF NOT USED
Pin 5
ON NOT USED
OFF NOT USED
Pin 6
ON NOT USED
OFF NOT USED