StarTech.com R300WN22MO5E - Manual (Page 8)

Instruction Manual
3
Hardware Installation
1. Connect the included power adapter to an available wall outlet and the DC jack to
the PoE injector.
2. Connect an Ethernet cable from the LAN port of the PoE Injector to your LAN switch
or router.
3. Connect a second, longer Ethernet cable from the PoE port of the PoE Injector. The
other end of this cable will connect to the AP as instructed in the following steps.
4. Unscrew the Cap portion of the Cable Grommet and remove the Collar.
5. Slide the Cap onto the cable first, then split the Collar and wrap it around the cable.
6. Connect the cable to the PoE port on the AP, then slide the Collar into the Grommet.
7. Thread the Cap over the assembly.
Note: The AP may take up to 2 mins to complete the power on sequence.
8. Connect an Ethernet cable from the LAN port of the PoE Injector to your LAN switch
or router.
Collar Cap