StarTech.com R150WN1X1T - Manual (Page 6)

Instruction Manual
2
LED Indicator
Power (Green) The AP is powered on
Wifi (Red) Wifi is operational
Reset Button
In order to reset the device to factory defaults:
1. Ensure the AP is connected to a power source.
2. Press and hold the reset button for 3 seconds (the red Wifi LED will turn off),
then release.
Installation
Default Settings
SSID: ComWi_xxxxxx
IP Address: 10.10.1.1
Hardware Installation
1. Connect an Ethernet cable to the WAN port on the bottom of the AP (with the
other end connected to the hotel wall jack/switch).
2. Slide the AP over your iPad power adapter and plug into a wall outlet, or use the
included USB extension cable to power the device through an available USB port /
other USB wall charger.
3. Connect your iPad / wireless devices to the “ComWi_xxxxxx” SSID and open
your web browser to access the Internet.
NOTE: If your hotel Internet requires a password or has a captive portal login,
contact the front desk to obtain that information from them.