StarTech.com SATDUP11 Manual - Manual (Page 19)

Instruction Manual
16
6.4 Advanced Setup
From Advanced Setup you can adjust HDD Wait Time, and lock the keys, see details
below.
a) Select “6.9 Advanced setup” using the navigation buttons.
b) From the “Advanced” menu you can select your desired application See the list
below outlining the details of each option.
Note: The number 6.9 at the beginning of each option below represents the
“Advanced Setup” heading on the main menu, the numbers: .1, .2, .3, etc. indicate
the option within the “Advanced Setup” sub menu.
6.4.1 Unknown Format
The Unknown Format function allows you to set how the device manages unknown
HDD area.
6.4.2 Erase Master
The Erase Master function can be enabled if you would also like to use the Source
Port as an erasing port.
6.4.3 Erase Pattern
This Erase Pattern function allows you to define the setting used to select different
erase methods.
6.4.4 Wait HDD Time
This is to set auto start time after plugging in HDD.
6.4.5 Transfer Rate
The Transfer Rate function allows you to select the best transfer rate from UDMA
2 to UDMA 4 for your HDD duplication progress. If you are not confident on the
HDD quality or you find a high failure rate on copy or compare. It is recommended
to slow down the UDMA mode.
6.4.6 Stop Motor Time
When the system finishes function executing, the motor won’t stop running
immediately. This function is used to set the time of motor stopping after finishing
function executing.
6.5 Restore Default
The Restore Default function sets the duplication setting back to the original
configuration.