StarTech.com SATDUP11IMG Quick Start - Manual (Page 6)

Instruction Manual
3
Hardware Installation
WARNING! Hard drives and drive duplicators require careful handling, especially
when being transported. If you are not careful with your hard disk, lost data may
result. Always handle your hard drive and duplicator device with caution. Be sure that
you are properly grounded by wearing an anti-static strap when handling computer
components or discharge yourself of any static electricity build-up by touching a large
grounded metal surface (such as the computer case) for several seconds.
1. Ensure the power switch is set in the off position. Using the included Universal
Power Adapter, connect the Power Adapter Port on the back of the
SATDUP11IMG to an available power outlet.
2. Connect your Source drive to the SATA SSD/HDD Source Port on the
SATDUP11IMG.
Note: The Source Drive can be drive you intend to make an exact copy of, or an
Image drive containing several hard drive images.
a) If the source drive is a SATA HDD/SSD, use the included Long SATA cable or the
included Short SATA cable depending on your preference.
b) If your source drive is an eSATA HDD/SSD, use the included eSATA + 12V Power
Cable or eSATA+5V Power Cable depending on your drive requirements.