StarTech.com S352BU33HR Manual - Manual (Page 13)

Instruction Manual
10
Enclosure
Powered On
Drives
being Accessed
Drive 2 Disconnected or
Dropped
Drive 2 Reconnected New Drive Connected Sleep
Both Drives Installed
and Detected
Blue
LED
Red
LED RAID
LED
Blue
LED
Red
LED RAID
LED
Blue
LED
Red
LED RAID
LED
Blue
LED
Red
LED RAID
LED
Blue
LED
Red
LED RAID
LED
Blue
LED
Red
LED RAID
LED
ON OFF
OFF
ON BLINK
OFF
ON OFF
SOLID
ON BLINK
BLINK
ON BLINK
BLINK
OFF OFF
OFF
ON OFF ON BLINK OFF SOLID ON BLINK ON BLINK OFF OFF
N/A
* The LEDs appear purple
because of the close
proximity of the Blue
and Red LEDs
* The DATA is still
accessible and can be
updated/modified even
though one of the drives
are disconnected.
* No power cycle
is required but
recommended.
* Data remains accessible
but no clear indication as
to if the RAID has been
fully repaired.
* Again LEDs look purple.
* RAID LED will turn
off after rebuild is
complete.
* No power cycle
is required but
recommended.
* Data remains
accessible but no clear
indication as to if the
RAID has been fully
repaired.
* Again LEDs look
purple.
* RAID LED will turn
off after rebuild is
complete.
*Support HDD spin-
down and LED off when
suspend/U3 command
*Support HDD spin-
down and LED off when
VBUS is gone
R1 (RAID1) – Mirroring
HDD
1
HDD
2
NOTE:
Enclosure
Powered On
Drives
being Accessed
Drive 2 Disconnected or
Dropped
Drive 2 Reconnected New Drive Connected Sleep
Both Drives Installed
and Detected
Blue
LED
Red
LED RAID
LED
Blue
LED
Red
LED RAID
LED
Blue
LED
Red
LED RAID
LED
Blue
LED
Red
LED RAID
LED
Blue
LED
Red
LED RAID
LED
Blue
LED
Red
LED RAID
LED
ON OFF
OFF
ON BLINK
OFF
ON OFF
SOLID
ON BLINK
SOLID
ON BLINK
SOLID
OFF OFF
OFF
ON OFF ON BLINK OFF SOLID ON BLINK ON BLINK OFF OFF
N/A
* The LEDs appear purple
because of the close
proximity of the Blue
and Red LEDs
* The drive will drop
from the system.
* The unit needs to be
power cycled before
it will pair up with the
drive again.
* Again LEDs look purple.
* RAID LED will turn
off after rebuild is
complete.
N/A
*Support HDD spin-
down and LED off when
suspend/U3 command
*Support HDD spin-
down and LED off when
VBUS is gone
R0 (RAID0) – Spanning
HDD
1
HDD
2
NOTE: