StarTech.com SV565UTP - Manual (Page 12)

Instruction Manual
9
Beep Codes
Some of the keyboard command sequences you issue to the Host Unit have multiple
possible settings. The Unit will beep to indicate what setting you have selected for
the command you issued. (A short beep followed by a long beep indicates an invalid
command.)
[Ctrl] - [Ctrl] - [Alt]+[E] (Compatibility Mode)
1 beep: disabled
2 beeps: enabled
[Ctrl] - [Ctrl] - [F3] (Inactivity Interval for Auto Mode)
1 beep: 5 seconds
2 beeps: 15 seconds
3 beeps: 30 seconds
4 beeps: 60 seconds
[Ctrl] - [Ctrl] - [F4] (Typematic Rate)
1 beep: 6 characters/sec.
2 beeps: 12 characters/sec.
3 beeps: 20 characters/sec.
4 beeps: 30 characters/sec.
Note: Commands described in the [Key] - [Key] format are keys that must be pressed
in order on the keyboard. Commands described in the [Key]+[Key] format must be
pressed simultaneously.
Note: If the Num Lock, Caps Lock, and Scroll Lock lights are flashing in unison on the
keyboard, the other Unit has control of Computer A. You will not be able to use the
computer or issue commands until the other unit has finished using the computer.
Note: If the Extender is operating in Compatability Mode ([Ctrl] - [Ctrl] -[E] (hotkey
sequence), you must enter [Ctrl] - [Ctrl] - [E] - [E] to access port E on the attached KVM
switch.