StarTech.com SV565USAGB - Manual (Page 12)

Instruction Manual
9
• vCtrl is too high, use manual control to decrease it
• RGB color skew may also need manual adjustment
• Test the Cat5 cable with a proper cable tester, to ensure cable integrity and signal
throughput
Blurry video or color skew
• Caused by skew between color channels, can be manually adjusted
• One value should remain zero, the other 2 can be adjusted up and down so all 3
color channels align up
• Only needs to be changed by a small amount for fine adjustment
• Test the Cat5 cable with a proper cable tester, to ensure cable integrity and signal
throughput
No keyboard or mouse, USB errors, no audio, no serial link, no test pattern
• Cable may be broken or unreliable, no communication between units
• Test the Cat5 cable with a proper cable tester, to ensure cable integrity and signal
throughput
• Unplug then plug in the power on Receiver and Transmitter units to restart them
Can’t get into serial menu
• Make sure serial port on PC is functioning and set up properly
• Make sure the right type of serial cable is used: straight-through for the Transmitter
unit (StarTech.com ID: MXT100), and null-modem for the Receiver Unit
(StarTech.com ID: SCNM9FF)
• If you are using the serial data link, use the same baud rate as the serial device or
other PC uses
• It may take several tries to enter the code since it depends on timing
• Unplug then plug in the power on Receiver and Transmitter units to restart them