StarTech.com SV411K - Manual (Page 6)

Instruction Manual
3
Using Your KVM Switch
The LEDs on the switch indicate which PC is active. You can scroll between PCs
by either pressing the push-button on the top of the switch or by using a hotkey
command. A hotkey command is a short sequence of keystrokes beginning with two
left Ctrl keystrokes followed by another keystroke. Use only the left Ctrl key and do not
use the keypad at the right of the keyboard.
Selecting a Computer
Command Hotkey Sequence
Select Computer 1 Left Ctrl + Left Ctrl + 1
Select Computer 2 Left Ctrl + Left Ctrl + 2
Select Computer 3 Left Ctrl + Left Ctrl + 3 (SV411, SV411K only)
Select Computer 4 Left Ctrl + Left Ctrl + 4 (Sv411, SV411K only)
Scroll between powered-
on computers
Left Ctrl + Left Ctrl + F2 + Up/Down Arrow
Auto-Scan Mode
Command Hotkey Sequence
Start auto-scan Left Ctrl + Left Ctrl + F1
End auto-scan Left Ctrl + Left Ctrl
Select auto-scan interval Left Ctrl + Left Ctrl + F3
Auto-scan mode will be suspended if the switch detects any keyboard or mouse
activity. When the activity ceases, auto-scan mode will resume. The auto-scan interval
can be set to 3 seconds (default setting, represented by one beep), 8 second (two
beeps), 15 seconds (three beeps), and 30 seconds (four beeps).