StarTech.com SV231DVIUAHR - Manual (Page 8)

Instruction Manual 5
Operation
Front Panel
On-line LED / Selected LED
When the LED turns green, the connected computer is powered-on. When a computer is
selected, its corresponding red LED illuminates.
Push Buttons
Pressing the “Select” button switches between ports.
HotKey Control
A Hotkey command is a short keyboard sequence for selecting a computer, activating computer
scan, etc. A hotkey sequence starts with two left keystrokes (successively within 0.2
seconds) followed by one or two more keystrokes. A built-in tone generator creates a high-pitch
beep for correct hotkey command; otherwise, one low-pitch beep is generated for errors and the
bad key sequence will not be forwarded to the selected computer.
NOTE: Press and hold Left and press twice, then release followed
by pressing left once, which will enable / disable the hotkey feature.
To select a computer:
Left + Left + <1>
(Example: Selects the computer at port 1.)
Left + Left + <2>
(Example: Selects the computer at port 2.)
NOTE: Do not use the keypad on the right-side of the keyboard.
Auto Scan
The KVM automatically scans through the powered-on computers in sequence on a fixed time
interval (see Scan Time below).