StarTech.com CAB1631D1U - Manual (Page 8)

Instruction Manual
5
The port number (or channel address) of the currently selected computer is displayed
in red in the top right of the screen.
The device name is green if the device has power and is ready for selection or white if
it has no power. The OSD menu automatically updates the color when it is activated.
On the 16-port models, use the and keys to view the other
8 computers.
Use the , , 1~8, or A~H keys to highlight a computer and to
select it.
Press to exit the OSD menu and remove the OSD menu from the screen.
A triangle mark on the right side of the screen indicates the port is cascaded to a
Slave KVM; the number at the left of the triangle mark shows the number of ports the
Slave has. With that port highlighted, press to bring up a screen listing the
computers connected to that Slave. The name of the Slave KVM will be shown at the
upper right corner of the OSD menu.
An eye mark on the right side of the screen indicates that the computer has been
selected to be monitored in Scan mode. You can switch this mark on and off using
function key .
Press to exit the OSD and to return to using the selected computer. The
computer name is shown on the screen.
OSD Function Keys
You can use the function keys when the OSD menu is active.
Function Key
Edits the name of a computer or a Slave KVM. First, use the and arrow
keys to highlight a channel then press followed by name entry. Your name can
be up to 14 characters long. Valid characters are A to Z, 0 to 9, and the dash character.
Lowercase letters are converted to uppercase. Press to delete a letter
one at a time. Non-volatile memory stores all name entries until you change, even if
the unit is powered down.
Function Key
Marks a computer to be scanned by switching the eye mark on or off. First, use the
and arrow keys to highlight the device, then press to switch its
eye mark on or off. If Scan Type is Ready PC + Eye (see Function key ), only the
powered and eye-marked computers will be displayed in Scan mode.