StarTech.com ST121HDT4P - Manual (Page 6)

Instruction Manual
3
Installation
Preparing Your Site
1. Determine where the local video source (i.e. computer, Blu-ray Player) will be
located and set up the device.
2. Determine where the remote display will be located and place/ mount the
display appropriately.
NOTE: This HDMI® extender kit features Power over cable, allowing both the
transmitter and Receiver to be powered from a single power source that connects
to the transmitter unit. Please ensure that the Transmitter Unit is situated near an
available AC electrical outlet. Make sure all devices are turned off before
beginning installation.
Hardware Installation
1. Install Transmitter Unit
a) Position the Transmitter Unit near the video source (i.e. Computer, Blu-ray Player).
b) Connect an HDMI® cable from the video source device (i.e. computer, Blu-ray
Player) to the “HDMI® IN” on the Transmitter Unit.
c) Connect the power supply.
d) (Optional) If using the Extender to extend one or two 10/100 Network signal(s),
connect the Ethernet cable(s) from the Network gateway to the 100Base-T IN Port(s)
on the Transmitter Unit.
e) (Optional) If using the Extender kit to transmit an infrared (IR) device signal, and
the device receiving the IR signal is on the Receiver side. Connect the IR Transmitter
Cable to the IR-RX port on the Transmitter Unit, and position the extended IR sensor
directly in front of the video source’s IR sensor. Check the manual of your video
source device for the IR sensor location. If the device receiving the IR signal is on
the Transmitter side, and connect the IR Transmitter Cable to the IR-TX port, and
position the IR sensor where the remote control will point.