Speeco S401635BB - Manual (Page 10)

Page 8
ITEM NO. DESCRIPTION QTY.
1 Tank Asembly 1
2 1/2” NC x 4-1/2 Hex Bolt 2
3 1/2” Lock Washer 2
4 1/2” NC Hex Nut 2
5 Tongue Assembly 1
STEP 3: Attach the tongue assembly (5) to the tank assembly (1) using two 1/2” NC x 4-1/2” hex cap bolts (2), two 1/2”
lock washers (3) and two 1/2” hex nuts (4). Tighten.
STEP 4: Stand the beam (1) up on end. Two people may be needed for this step to ensure safety. Make sure that the
beam is stable and on a level surface.Remove the pivot pin (3) and clip pin (2) from the tank assembly.Roll the
tongue/ tank assembly into position between the two tabs on the beam (1). Slide the pivot pin (3) through the
aligned holes and lock in place with the clip pin (2).
ITEM NO. DESCRIPTION QTY.
1 Beam Assembly 1
2 1/2”-3/4” R Clip Pin 1
3 Pivot Pin 1