Source Audio Soundblox Pro Classic Distortion Pro - Manual (Page 7)

Controls: Footswitches | 13 12 | Controls: Other Buttons
CONTROLS: FOOTSWITCHES
There are three footswitches on the Classic Pro. From left to right, the
footswitches correspond to presets
1 , 2 , and 3 for preset bank A and 4 , 5 ,
and 6 for bank B. Pressing any of the buttons will engage a given preset.
Pressing the footswitch for the currently engaged effect will put the unit
into bypass mode. Pressing another switch will engage that effect with-
out going into bypass.
The indicator lights above the three footswitches are bi-color and will
change depending on which bank is selected. Bank A presets are green
while bank B presets are red. When a preset is edited, the
LED will begin
to blink occasionally to show that the preset has been changed. When a
preset has been edited, pressing and holding any of the switches will save
the changes to the corresponding preset. The
LED will blink quickly to
indicate that the preset has been saved. Once changes are saved, the LED
will be lit solidly. See the Preset Saving section for other saving options.
Note: Changes made to a preset will be lost if you go into bypass or
switch to another preset without saving!
CONTROLS: OTHER BUTTONS
PRESET BANK
There are six available user presets that are in two banks. The bank can
be switched by pressing the
PRESET BANK button. When preset bank A is
selected, pressing the corresponding footswitches will select presets 1 ,
2 , or 3 . When preset bank B is selected, the footswitches select presets
4 , 5 , and 6 . The indicator lights (LEDs) above each footswitch will be green
for bank A and red for bank B.
HH ENABLE
The Hot Hand enable button enables or disables Hot Hand control for the
selected preset. This way, Hot Hand control can be set up for an individual
preset and can be left off otherwise.
CALIBRATE
Pressing this button when the pedal is engaged will turn on calibration
mode. Calibration mode allows you set a zero point for an attached Hot
Hand sensor. Calibration can only be enabled when
HH ENABLE is on.
HH ENABLE
CALIBRATE
BACKPAGE
MODE
125 250 500 1K 2K
(NG) (HG) (HS) (HA) (HR)
4K 8K
+12
-12
0
< >
+12
-12
0
DRIVE 1 MIDRANGE
CLEAN BOOST / EQ
DRIVE 2 OUTPUT
HH ENABLE
CALIBRATE PRESET BANK
4-6 1-3
BACKPAGE
MODE
BENDER
SMOOTH TUBE
POWER STAGE
CRUNCH TUBE
TS9000
BIG PI
EL RATON
FUZZ FAÇADE
METAL
OCTAVE FUZZ TUBE DRIVE
0
CLASSIC DISTORTION
1 4
2 5
3 6
PRESET BANK
4-6 1-3
Bank B Bank A